Pre-Operation Check - Honda FJ500 Owner's Manual

4. PRE-OPERATION CHECK

Place the tiller on a firm level surface and hold the tiller level (i.e. with
the rotary tines, front wheel (DE and DER types) and drag bar (see page
15)). Stop the engine before starting service of the tiller. Servicing the
tiller on an unstable surface of the ground or without stopping the
engine can cause injury and/or equipment damage.
Daily inspection and service of tiller is essential for safe and reliable
operation. Perform the following check before operation.
1.Tiller outside
Check for fuel and engine oil leaks.
Make sure that there are no flammable materials (dust, straw, etc.) near
the engine.
2.Control lever function
Check that the lever operates smoothly.
3.Wiring and cables
Check the insulation of each wire and cable for tears and cuts.
Check if there is any wire or cable pinched by the neighboring parts.
4.Engine operation
• Start the engine. Check for abnormal sounds. (See pages 23 through
25 for starting procedure.)
• Check that the engine stops securely by operating the engine switch.
(See pages 37 through 39 for stopping procedure.)
• If you notice any other abnormal symptoms, consult with your
authorized Honda dealer promptly.
5.Bolts and nuts
Check for looseness in fastened parts. Securely tighten all loose parts.
14