Honda FJ500 Manual page 123

62V42000.book 14 ページ ２０１２年１２月７日 金曜日 午前９時１７分
dummyhead dummyhead
ROTOR/TRANSMISSION
FRONT WHEEL REMOVAL/INSTALLATION (DER, DE TYPE)
FRONT WHEEL BEAM
GUIDE WASHER
Note the installation
direction.
FRONT WHEEL
ARM SIDE
(Sliding surface)
FRONT WHEEL ARM SHAFT
BOLT (8 x 80 mm)
FRONT WHEEL: NOTE 2
NOTE 1
NOTE 2
NOTE 3
15-14
NUT (10 mm) (2)
NUT (8 mm)
(Sliding surface)
FRONT WHEEL COLLAR
Tighten the castle nut, then loosen it until its grooves align with the hole of
the shaft.
After installation, check the wheel for smooth operation.
After installation, check the front wheel arm for smooth operation.
BOLT (10 x 40 mm) (2)
RETURN SPRING (2)
WASHER (8 mm)
CASTLE NUT (8 mm): NOTE 1
SPLIT PIN
FRONT WHEEL ARM: NOTE 3
–
–
–