Honda FJ500 Manual page 131

CRANKSHAFT BEARING/OIL SEAL
REPLACEMENT
• 62V4200: page 13-12
CRANKSHAFT BEARING
(SER2/SE2/DER2/DE2 TYPE)
CRANKCASE COVER SIDE
Remove the oil seal and drive out the crankshaft bearing.
Drive a new crankshaft bearing [1] until it is fully seated on the end using the
special tools.
TOOLS:
Attachment, 52 x 55 mm [2]
Pilot, 25 mm [3]
Driver [4]
CYLINDER BARREL SIDE
Install the flywheel nut [1] tightening the flywheel to protect the crankshaft
threads.
Pull out the radial ball bearing [2] using a commercially available bearing
puller [3].
Apply oil to the inner surface of the new bearing [4] inner race [5].
Drive the radial ball bearing until it is fully seated on the end using the spe-
cial tools and hydraulic press.
TOOLS:
Attachment, 25 mm [6]
Inner driver handle, 40 mm [7] 07746-0030100
07746-0010400
07746-0040600
07749-0010000
07746-0030200
[4]
[2]
[7]
[6]
[4]
3
[3]
[2]
[1]
[3]
[5]
[1]