Pre-Operation Check - Honda F220K1 Owner's Manual

Before each use, look around and underneath the engine for signs of oil or
gasoline leaks.
Place the tiller on a firm level surface and hold the tiller level (i.e. with the
rotary tines, front wheel (if equipped) and drag bar). Stop the engine
before starting service of the tiller. Servicing the tiller on an unstable
surface of the ground or without stopping the engine can cause injury and/
or equipment damage.
Daily inspection and service of tiller is essential for safe and reliable operation.
Perform the following check before operation.
1. Tiller outside
Check for fuel and engine oil leaks.
Make sure that there are no flammable materials (dust, straw, etc.) near the
engine.
2. Control lever function
Check that the lever operates smoothly.
3. Wiring and cables
Check the insulation of each wire and cable for tears and cuts.
Check if there is any wire or cable pinched by the neighboring parts.
4. Bolts and nuts tightens
Check for looseness in fastened parts. Securely tighten all loose parts.
5. Tines
Check for excessive wear, damage, or looseness.
6. Engine operation
• Start the engine. Check for abnormal sounds. (See pages 21 through 22 for
starting procedure.)
• Check that the engine stops securely by operating the engine switch. (See
pages 28 and 30 for stopping procedure.)
• If you notice any other abnormal symptoms, consult with your authorized
Honda dealer promptly.

4. PRE-OPERATION CHECK

13