Honda FJ500 Manual page 48

62V42000.book 7 ページ ２０１２年１２月７日 金曜日 午前９時１７分
dummyhead dummyhead
PILOT JET: NOTE 7, 8
O-RING
(Whole surface)
THROTTLE STOP SCREW
MAIN NOZZLE: NOTE 7
MAIN JET (MAIN JET NUMBER: #68):
NOTE 7
FLOAT: NOTE 3, 6
FLOAT PIN
O-RING
FLOAT CHAMBER
FLOAT CHAMBER SCREW
(5 x 12 mm) (2)
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
SEDIMENT CUP
4.5 N·m (0.5 kgf·m, 3.3 lbf·ft)
CHOKE LEVER
CHOKE SHAFT
WASHER
DUST SEAL
STOP SCREW (3 x 4 mm)
0.7 N·m (0.07 kgf·m, 0.5 lbf·ft)
FLOAT VALVE: NOTE 4
VALVE SEAL:
NOTE 1
SPRING
O-RING
STOPPER BUTTON
WAVE WASHER
NOTE 1 VALVE SEAL INSTALLATION
NOTE 2 LUBRICATION
NOTE 3 FLOAT LEVEL HEIGHT INSPECTION
NOTE 4 FLOAT VALVE INSPECTION
NOTE 5 CARBURETOR BODY CLEANING
NOTE 6 After installation, check for smooth movement.
NOTE 7 Before installing, clean thoroughly with low pressure compressed air.
When installation, lightly lubricate a new O-ring to ensure easy installation
NOTE 8
into the carburetor body.
NOTE 9 Install it in the direction as shown.
CHOKE LEVER PIN
CARBURETOR BODY: NOTE 5
CHOKE PLATE
BOWL VENT BAFFLE
BAFFLE SCREW (3 x 7 mm)
0.8 N·m (0.08 kgf·m, 0.6 lbf·ft)
FUEL VALVE: NOTE 2, 9
O-RING
FUEL VALVE COVER: NOTE 2
VALVE COVER SCREW (3 x 5 mm) (2)
0.8 N·m (0.08 kgf·m, 0.6 lbf·ft)
FUEL SYSTEM
(Threads)
FUEL VALVE LEVER SCREW
(3 x 11 mm): NOTE 2
0.7 N·m (0.07 kgf·m, 0.5 lbf·ft)
FUEL VALVE LEVER
page 5-8
page 5-8
page 5-9
page 5-9
page 5-10
–
–
–
–
5-7