Replacement Of Bobbin - Brother BE-0901E-AC-PC Instruction Manual

Chapter 2 Preparation of Embroidery Machine

3-2 Replacement of Bobbin

Note) Remove dust, lint and oil from the bobbin case before replacement.
! ! ! ! Removing bobbin case
[2]
[1]
! ! ! ! Replacing bobbin
[5]
[6]
Pull out by
about 50 mm
2-14
[3]
W1576
W1238Q W1577
[4]
W1238Q W1578
W1238Q W1579
BE-0901E-AC-PC• BE-1201B-AC-PC
1. Open the rotary hook cover [1].
2. Hold the knob [2] and take out the bobbin
case.
3. Close the knob and take out the bobbin [3].
1. Put a new bobbin in the bobbin case.
Check the winding direction. (refer the figure)
If the bobbin is inserted in the reverse
direction, the lower thread may slip too much,
resultingin a problem in embroidering.
Check that the bobbin is pushed out of the
bobbin case by about 0.5 mm. If not, the slip
prevention spring of the bobbin case does not
work. Adjust the height of the spring or
replace it with a new one.
Bobbin
2. Slide the thread under the tension spring [5]
through the notch [4].
3. Pull out the thread from the hole of the
tension spring [5].
4. Pull out the thread by about 50 mm.
0.5mm
W1580