Brother BE-0901E-AC-PC Instruction Manual page 231

Code
Hoop overhang (+X)
E-21
Hoop overhang (+Y)
E-22
Hoop overhang (+X, +Y)
E-23
Hoop overhang (-X)
E-24
E-25 Hoop overhang (+X, -X)
Hoop overhang (-X, +Y)
E-26
Hoop overhang (+X, -X, +Y)
E-27
Hoop overhang (-Y)
E-28
Hoop overhang (+X, -Y)
E-29
Hoop overhang (+Y, -Y)
E-2A
Hoop overhang (+X, +Y, -Y)
E-2B
Hoop overhang (-X, -Y)
E-2C
Hoop overhang (+X, -X, -Y)
E-2D
Hoop overhang (-X, +Y, -Y)
E-2E
E-2F Hoop overhang (+X, -X, +Y, -Y)
E-31 Needle overhang (+X)
Needle overhang (+Y)
E-32
Needle overhang (+X, +Y)
E-33
Needle overhang (-X)
E-34
Needle overhang (-X, +Y)
E-36
Needle overhang (-Y)
E-38
Needle overhang (+X, -Y)
E-39
Needle overhang (-X, -Y)
E-3C
E-41 Invalid start-up error
E-42 XY movement error
E-43 Slave I/F EEPROM read error
E-A1 Spindle motor lock
E-A5 Spindle motor CPU error
Main shaft motor CPU communication
E-A6
command error
E-A7 Main shaft motor CPU send/receive error
E-A8 Main shaft stop position signal error
E-A9 Spindle CPU parameter error
E-C1 Area over during embroidering
E-C2 Wiper out error
E-C3 Embroidering data buffer empty
E-C9 Embroidering start error
E-CA No sewing permisson
Error
BE-0901E-AC-PC• BE-1201B-AC-PC
Pattern or the needle position is out of the embroidering area.
Reset the embroidering area on the panel or move the hoop to
the sewable position.
Turn the power off and on once.
Press the .
Turn the power off and on once. If the same error occurs again,
the main PC is faulty.
Press the If it occurs frequently, the main shaft
mechanism is faulty.
This is not usually displayed.
Adjust the pulley stop position (100 degrees) above the needle
and press the If the error occurs frequently, the parts
related to the main shaft stop position sensor are faulty.
This is not usually displayed.
Set the embroidering area again on the panel.
If the wiper is tangled with a thread, remove it. Press the
This is not usually displayed.
Chapter 11 Error code list
Measures
.
11-3