Brother BE-0901E-AC-PC Instruction Manual page 230

Chapter 11 Error code list
Code
E-00 No error occurs.
E-01ERROR 01Either motor of main shaft, X-
E-01
or Y-axis has locked..
Overtravel occurs during home position
E-02
detecting movement.
The stop switch is pressed during home
E-03
position detecting movement.
E-04 Zero detecting movement out of range
E-05 Needle stop position error
E-06 Needle bar case position error
E-07 Needle bar case lock
Stop switch or emergency switch was pressed
E-08
while the needle bar case is traveling.
E-09 X-axis home position detection error
E-0A Thread breaking error
E-0B Stop or emergency stop during sewing
E-0C Insufficient bobbin thread
The machine does not return to the home
E-0D
position.
E-0F Undefined error
E-14 Y-axis home position error
Stop error during SSP processing (when
E-15
pressing the stop key while the hoop is moving)
Needle with specified number is out of movable
E-16
area.
E-17 Speed Vol. No. is out of range.
E-1A Destination coordinates error
E-1C The machine stops during mask tracing.
The machine stops while the needle is moving
E-1D
between patterns during repeat sewing.
Presser foot down error while searching for
E-1F
home position just after the power is turned on.
11-2
Error
BE-0901E-AC-PC• BE-1201B-AC-PC
This is not usually displayed.
Turn the power off and on once. If the same error occurs again,
the area sensor is faulty.
Press the to restart the home position detecting
movement again.
Turn the power off and on once. If the same error occurs again,
the home position sensor is faulty.
Adjust the pulley stop position (100 degrees) above the needle
and press the .
This is not usually displayed.
Press the . If the same error occurs again, the color
change mechanism is faulty.
This is not usually displayed.
Turn the power off and on once. If the same error occurs again,
the X-axis mechanism is faulty.
After passing through the thread, press the
This is not usually displayed.
Turn the power off and on once. If the same error occurs again,
the Y-axis mechanism is faulty.
Hoop movement restarts if you press
This is not usually displayed.
Tracing is cancelled if the
machine is stopped during mask tracing. Press the
to continue tracing
This is displayed when the stop switch is pressed while the
hoop is moving. Press the
necessary to press the
Press the . If the same error occurs again, adjust the
presser foot switch.
Measures
.
.
key is pressed when the
to move the hoop again. (It is
again to start sewing.)
key