Network Port Test; Network Port Pxe - Inspur NF5280M5 Acceptance Manual

4.1.1 Network Port PXE

Table 4-1 Network Port PXE
Item
Objective
Prerequisites
Procedure
Expected result
Description
Note:
(1) Before acceptance, the system should be properly installed, and the software and
hardware debugging should pass, and the system can run normally.
(2)
The acceptance project should be confirmed by relevant personnel of both Inspur and
the user.
(3)
During the acceptance and preliminary inspection tests, the personnel of both parties
shall perform strict tests against relevant standards. Some index parameters have been
tested when leaving the factory. When acceptance is limited, the conditions may be random
or exempt.
Copyright © Inspur Electronic Information Industry Co., Ltd.
4
Content
To verify that LOM ports on the server support PXE.
1. The server is powered on.
2. The Dynamic Host Configuration Protocol (DHCP) server
is configured properly.
3. The installation server is configured properly
4. The DHCP server and installation server are connected to
NIC1 on the server over the network.
Power on the server and wait until it starts.
Press F12 on the first BIOS screen.
The server starts over PXE.
An IP address is obtained for the server.
The server starts to install an OS over the network.
None
Inspur proprietary and confidential information

Network Port Test

25