Inspur NF5280M5 Acceptance Manual page 18

Expected result
Description
Table 2-6 Web Interface—Firmware Upgrade on the WebUI
Item
Objective
Prerequisites
Procedure
Copyright © Inspur Electronic Information Industry Co., Ltd.
new IP address is on the same network segment as that of
the terminal.
6. Use the new IP address to log in to the BMC WebUI.
1. The IP address is properly configured.
2. The new IP address, subnet mask, and gateway are
displayed on the WebUI.
3. The new IP address takes effect and can be used to log in.
After the new IP address is configured or obtained, use the new
IP address to log in again.
Content
To verify that you can upgrade the firmware on the WebUI.
AC power is supplied to the server.
The BMC network port IP address has been set.
Internet Explorer 8.0/9.0/10.0, Firefox 9.0 has been installed on
the terminal.
The terminal is connected to the BMC network port on the
target server over the network.
1. In the address
(xxx.xxx.xxx.xxx is the static BMC ip address that has
been set)
2. Enter the user name root and the default password, and
click Log In.
3. Choose System > Firmware Upgrade, the Firmware
Upgrade page is displayed.
4. Select the BMC software upgrade package and click
Upgrade.
Inspur proprietary and confidential information
box, enter http://xxx.xxx.xxx.xxx
17