Table of Contents
Advertisement
Before Asking for Repairs
When the problem cannot be rectified even if an inspection is made according to the table shown
below, immediately stop using the machine, turn off the power switch, disconnect the power plug,
and immediately contact the nearest dealer or our company directly.
Phenomenon
The power cannot be
turned on
(No indication on the
control panel)
The power cannot be
turned on though the
power switch is set to
the "ON" position.
Mist does not come out.
The temperature of mist
is low or high.
Mist leaks from around
the mist cap.
Water leaks from the
drain outlet.
Disposing of the Product
The product must be disposed according to the law of the country where the product is used.
Check Point
Is the power plug correctly inserted
into the wall outlet?
Is the power switch turned on?
Is the fuse on the distribution panel
or the breaker switch in the shop in
the "ON" position?
Is the problem not rectified when the
power plug is disconnected and is
then inserted again?
Failure of the machine might be
suspected.
When either of the previous
indications blink,
see the section "State Indication"
on page 26.
Check that water accumulates in the
flexible hose.
Check that the temperature level
setting is correct.
Check that water accumulates in the
flexible hose.
Check that a space exists between the
turban and the mist cap.
Check that the hook and loop fasteners
of the mist cap is robustly fixed.
Check that the drain cock is closed.
27
Countermeasures
Insert the power plug firmly into
the wall socket.
Set the power switch to the "ON"
position.
Set the fuse on the distribution
panel or the breaker switch to the
"ON" position.
Immediately stop using the machine,
turn off the power switch, disconnect
the power plug, and then immediately
contact the nearest dealer or our
company directly.
Immediately stop using the machine,
turn off the power switch, disconnect
the power plug, and then immediately
contact the nearest dealer or our
company directly.
When the problem cannot be rectified
even if the measures are taken,
immediately stop using the machine,
turn off the power switch, disconnect
the power plug, and then immediately
contact the nearest dealer or our
company directly.
Discharge the water accumulated in
the flexible hose.
Execute setting up of the temperature
level key again.
Discharge the water accumulated in
the flexible hose.
Reset the mist cap in the manner to
eliminate any space.
Reset the fastener in the manner to
eliminate any space.
Close the drain cock.
Advertisement
Table of Contents
