Table of Contents
Advertisement
Guida n ce on Da i ly In spec tio n
■Items to be inspected on a daily basis (Inspection before starting the work)
Inspection Item
□Check that the power switch
operates correctly and the
lamps on the control panel
illuminate.
□Check that the flexible hose
is broken or twisted.
□Check that there is no flaw or
crack on the water-supply
bottle or the drain tank.
□Check that hair is not tangled
on the caster.
■Items to be inspected on a daily basis (Inspection before closing the work)
□When closing the work, drain the water accumulated in the machine, and clear out the water
accumulated in the drain tank. (See page 14)
M ain Spe c if i ca t i o ns
Model No.
Electrical reguirements
Water-supply Bottle
CapacityDrain Tank
CapacityDimensions
Weight
Inspection Procedures
When operating the power switch,
there shall be no problems such as
jamming of the power switch.
In addition, check that all lamps
illuminate when the power switch is
turned on.
Give a visual check.
Give a visual check.
Give a visual check.
AC110V
AC220V
AC240V
330(W)×355(D)×750(H)mm
※Respective specifications are subject to change without notice.
29
Possible hazard when the
inspection revealed NG
When the product is used in the
condition where the power switch is
not operated correctly, there is a
possibility of failures such as the
power becoming disconnected
unexpectedly during operation.In
addition, in the condition where the
lamps on the control panel do not
illuminate, the product may not be
used properly because the setup
state cannot be confirmed.If this is
the case, immediately stop using the
machine, turn off the power switch,
disconnect the power plug, and then
immediately contact the nearest
dealer or our company directly.
Using the machine with the hose
bended or twisted may make it
difficult to atomize the mist and
causemachine failure or accidents
due to temperature increases.Be sure
to restore the hose to the original
shape.If it is hard to restore it to
the original shape, immediately stop
using the machine, turn off the power
switch, disconnect the power plug,
and then immediately contact the
nearest dealer or our company directly.
If any flaws or cracks are noted,
immediately stop using the machine,
turn off the power switch, disconnect
the power plug, and then immediately
contact the nearest dealer or our
company directly.
In case hair is tangled on the caster,
remove the hair by referring to the
daily inspection and maintenance
procedures of the caster.
（
Dimensions and weight are
for the stand-alone type
AK-160
4.6A
AC120V
4.2A
2.1A
AC230V
2.2A
2.1A
1400mL
450mL
15.2kg
）
50/60
Hz
Advertisement
Table of Contents
