Table of Contents
Advertisement
62
en | Troubleshooting Guide
8
Troubleshooting Guide
8.1
VG5 AutoDome Operation and Control
Problem
Solution
No video
–
If the Green LED is off, then:
–
Red LED on AutoDome CPU M0.odule
Flash SequenceIndicates:
–
–
If the Red LED is on steady, then:
–
If the Red LED is off, then:
If using a Bosch Pendant Power Supply Box:
–
If the Green LED is off, then:
–
–
If O.K., then:
–
If O.K., then:
If using a non-Bosch power supply:
–
If O.K., then:
–
–
If O.K., then:
–
If O.K., then:
If there is power to the AutoDome, then:
–
If the Green LED is off, then:
–
2014.11 | 2.1 | F.01U.270.005
Check that the Green LED on the AutoDome CPU board is on. This LED indicates video
from the camera.
Check that the Red LED on the AutoDome CPU board is slowly blinking. This LED
indicates power to the AutoDome power supply board and to the CPU Module.
5 sec. on / 0.5 sec. off: Normal operation
Steady on: CPU is locked
Try cycling the AutoDome power off and on.
Check that Green LED in Power Supply Box is on. This LED indicates mains power
through the transformer.
Turn off the Power.
Check the FX101 fuse for mains power to the Power Supply Box.
Check the FX102 fuse for 24 V power to the AutoDome Pendant.
Check that the mains power to the power supply box is on.
Check that there is 24 V output from the transformer.
Check the connector on top of the AutoDome housing for bent pins.
Check the integrity of all wires and terminal connections to the AutoDome.
Remove the camera and CPU modules from the AutoDome housing and check that the
Green LED on the housing power supply board is on.
Check that the fuse on the housing power supply board is good.
User Manual
AutoDome 600 Series Analog PTZ
Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
