Specifying Data Settings - JDS Uniphase HST-3000 User Manual

Specifying Data
settings
The following settings must be specified:
– Data Settings (see
– 802.1x Authentication Settings (see
security settings" on page
– STUN settings (see
page 14)
– PPP Settings (see
– WAN Settings (see
page 16)
For more information on other configuration items (Ping,
Trace Route, and so on), see the HST-3000 ADSL2 Testing
User's Guide or the HST-3000 VDSL Testing User's Guide.
The Data settings menu varies, depending on the interface.
The following procedure describes how to set the Data
settings.
To specify Data settings
1 Select the interface (ADSL, VDSL, or Ethernet).
2 Do one of the following.
– From the main ADSL or VDSL Measurements screen,
select the Data application.
– From main Ethernet Measurements screen, select
Ethernet TE.
3 Press the Configure
The parameter soft keys appear.
4 Press the DATA soft key.
CAUTION: FAULTY RESULTS
Changing these settings during a test may cause errors in
the test. Only change them before you begin a test.
The Data Settings menu appears.
HST-3000 IP Video Testing User's Guide
"Specifying Data settings" on page
13)
"Specifying STUN settings" on
"Specifying PPP settings" on page
"Specifying WAN settings" on
navigation key.
Chapter 2 IP Video Testing
Specifying test settings
"Specifying 802.1x
9)
15)
9