Installing Eternity Genx; Before You Start - Matrix Telecom SARVAM UMG Quick Start Manual

Before you Start

Before you begin the installation of the ETERNITY GENX, make sure that the required telecom
wiring has been done and you have the following items ready:
• SARVAM UMG SME License.
• A Main Distribution Frame (MDF).
• A suitable location to install the Main Distribution Frame and the ETERNITY GENX platform. If
you want to install the mobile card, make sure the place you select has sufficient signal
strength.
• Cables for trunk lines and extensions.
Terminate the trunk lines from the service provider network and the extension lines from the
phones into the Main Distribution Frame.
• The Cards of ETERNITY GENX, as required.
• One or more Single Line Telephone for testing.
• Power supply.
The ETERNITY GENX works with input voltages ranging between 100-240VAC or with 48VDC.
Arrange for a separate power point and switch, close to the system. Power supply for the
system must be separate from other heavy electrical loads like Air-conditioners, heaters,
welding machines, electrical motors, etc.
• One or more active Two-wire Trunk lines (CO lines) for test calls.
• A modem for the ISDN T1E1PRI line.
• An NT1 termination device for the ISDN BRI line.
• Appropriate cables and connectors to set up and test the WAN interface of the ETERNITY
GENX and the LAN connection.
Matrix SARVAM UMG Quick Start

Installing ETERNITY GENX

5