Installing Mobile Card - Matrix Telecom SARVAM UMG Quick Start Manual

Installing Mobile Card

Unpack the Mobile Card.
•
• Connect the antenna (provided with the Mobile card) to the connector on the Mobile card.
• You may enable PIN Protection on your SIM card before inserting it into the Mobile Port to
protect it form unauthorized use.
Disable Call Waiting in the SIM, else it may result in call disconnection.
• If you want to use PIN Protection,
• Insert the SIM into a mobile handset first.
• Enable PIN Protection from the mobile handset.
• Assign the desired SIM PIN value.
• Remove the SIM from the mobile handset.
• Insert the SIM card (contact facing down) into the SIM holders on the GSM Card. Refer to
the illustration given below.
If you do not want to use PIN protection, insert the SIM in the mobile handset and disable PIN
protection.
Failure to follow the instructions on PIN protection may cause your SIM Card to be blocked and you
will require Personal Unblocking Number (PUK) to reactivate it again.
ETERNITY GENX support both types of Mobile Cards - with SIM Hot-swap and without SIM
Hot-swap. Hot-swap allows you to insert or remove a SIM card from the SIM holder (present
on the fascia of the Mobile card) without switching off the system.
SIM Hot-swap is supported for ETERNITY GE CARD GSM4, ETERNITY GE CARD GSM4 3G having
hardware design V2R2, CPLD Version Revision V2R2 and PCB Version Revision V2R1 and later and
ETERNITY GE CARD GSM4 4G.
Matrix SARVAM UMG Quick Start 17