Epson AcuLaser C2800 Service Manual page 292

AcuLaser C2800/C2800D/C3800/C3800D
B
3)
3)
Handle (ROS ASSY)
DISASSEMBLY/REASSEMBLY
LVPS
(P501) (P504)
1)
2)-1
2)-2 (P503)
(P44)
1)
(P40)
(P502)
1)
2)-1
(P47)
(P48)
4)
3)
3)
Kmy03065EC
NEXT>>
Disassembly/Reassembly
Do not remove/install the board in areas where static sparks may be generated.
(e.g. on a carpet) Be sure to touch a metal part to discharge any static electricity you might
have before removing/installing the board.
1. Disconnect all the connectors on the LVPS and release the harnesses from the clamps.
2. Remove the clamps that secure the harness of the HARNESS ASSY INTERLOCK and that of the
HARN ASSY INLET from the SHIELD LVPS.
1)
3. Remove the two screws (silver, self-tapping, 10 mm) and the three screws (silver, 6 mm) that secure
the SHIELD LVPS to the main unit.
1)
4. Remove the SHIELD LVPS together with the LVPS from the main unit.
The SHIELD LVPS should be placed underneath the PLATE EARTH as shown in the
figure.
Hold down the handle if the undersurface of the SHIELD LVPS interferes the handle of
the ROS ASSY.
3)
Revision C
NEXT>>
292
Confidential