Epson AcuLaser C2800 Service Manual page 258

AcuLaser C2800/C2800D/C3800/C3800D
8)-2
Make sure that the ground wire (green), HARNESS ASSY-CON F (white), and HARNESS
ASSY FRONT COVER (black), which are coming out of the COVER ASSY FRONT, are
routed as shown in figure-B.
6. Disconnect the connector (P/J236) of the SOLENOID FEED MSI.
7. Release the harness of the SOLENOID FEED MSI and the HARNESS ASSY MSI NPP from the
DUCT DRV PH.
8. Release the tab of the DUCT DRV PH, and remove the DUCT DRV PH together with the harness
from the DRIVE ASSY PH.
DISASSEMBLY/REASSEMBLY
8)-1
Kmy03060EB
9. Remove the four screws (silver, self-tapping, 10 mm) that secure the DRIVE ASSY PH to the main
10. Remove the DRIVE ASSY PH from the main unit.
11. Disconnect the connector (P/J251) of the DRIVE ASSY PH.
NEXT>>
Disassembly/Reassembly
DRIVE ASSY PH
Kmy03061EB
unit.
Do not pull the DRIVE ASSY PH too far from the main unit as they are connected with a
harness.
The harness connected to the DEVE MOTOR of the DRIVE ASSY MAIN should pass the
far side of the tab on the DRIVE ASSY PH.
Revision C
11)
10)
9)
9)
9)
9)
NEXT>>
258
Confidential