Epson AcuLaser C2800 Service Manual page 290

AcuLaser C2800/C2800D/C3800/C3800D
B C
1)
2)
2)
LABEL
7)
6)
6)
FAN MAIN
1. Disconnect the connector (P/J503) of the FAN MAIN on the LVPS.
2. Loosen the clamp that secures the harness of the FAN MAIN, and detach the harness.
3. Release the harness from the tab on the main unit.
4. Remove the two screws (silver, self-tapping, 35 mm) that secure both the DUCT FAN MAIN and the
FAN MAIN.
5. Remove the DUCT FAN MAIN together with the FAN MAIN.
6. Remove the two screws (silver, self-tapping, 35 mm) that secure FAN MAIN to the DUCT FAN MAIN.
7. Remove the FAN MAIN from the DUCT FAN MAIN.
Mind the correct orientation when installing the FAN MAIN. The label on the FAN
MAIN should be facing front.
Pass the harness of the FAN MAIN through the cutout of the DUCT FAN MAIN.
DISASSEMBLY/REASSEMBLY
FAN MAIN
3)
4)
Kmy03067EC
Disassembly/Reassembly
B C
5)
4)
Do not remove/install the board in areas where static sparks may be generated.
(e.g. on a carpet) Be sure to touch a metal part to discharge any static electricity you
might have before removing/installing the board.
1. Remove the nine screws (silver, 6 mm) that secure the COVER ASSY ESS E to the main unit.
2. Remove the COVER ASSY ESS E together with the COVER OPTION from the main unit.
SHIELD ASSY ESS
2)
1)
1)
1)
1)
Kmy03073EC 1)
1)
Revision C
1)
1)
1)
NEXT>>
290
Confidential