Functions - Breville Oracle Instruction Book

Functions

FIRST USE
1. Ensure tank is filled with cold water.
You can do this by either opening the
top-fill water tank lid (push to open), or
by removing the water tank at the back
of the machine.
2. Press POWER button to turn machine on.
3. The main LCD will display 'Hrd3',
prompting you to set the water hardness
level. Programming this will determine the
regularity of the 'CHANGE FILTER' alert
which indicates when the water filter in the
water tank needs to be replaced.
Setting Water Hardness
• Remove the supplied water hardness
test strip from the wrapper.
• Dip the test strip into a sample of the
water you have filled the tank with. Wait
for one minute. The water hardness setting
is indicated by the number of red squares
displayed on the test strip eg. 3 red squares
indicates a water hardness setting of 3.
• Rotate SELECT dial to the required setting
from 'Hrd1' (softest water) to 'Hrd5' (hardest
water). Press SELECT dial to set. Machine
will beep once to confirm selection.
4. A pumping/vibrating sound will be heard
indicating empty boilers are being filled
with water for the first time. The main LCD
will display the current boiler temperature
and flash 'HEATING'.
5. After approximately 10 minutes, the
machine will reach the default operating
temperature (200˚F/93˚C) and all 6
buttons will illuminate. The machine is now
in STANDBY mode, ready for the next step,
'Flushing The Machine'.
POWER
FLUSHING THE MACHINE
1. When the machine has reached
STANDBY mode:
2. Press 2 CUP button to run water through
the group head for 30 seconds.
3. Press HOT WATER button to run water
through the hot water outlet. After 30
seconds, press HOT WATER button again
to stop the flow of water.
4. Lift steam lever to the MANUAL position
to release steam through the steam wand.
After 30 seconds, lower the steam lever to
the center OFF position.
5. Repeat steps 1–3 twice.
6. Re-fill water tank and empty drip tray,
if required.
MANUAL WILL FLASH ON LCD
The machine will not reach operating
temperature (STANDBY mode) if the steam
lever is in the MANUAL position. The steam
LCD will display 'MANUAL'. Lower the steam
lever to the center OFF position.
Steam operation is ready when the SELECT
dial illuminates.
NOTE
You will not be able to select the
1 CUP, 2 CUP or AMERICANO functions; or
access the cleaning cycle in the menu options
until the machine has reached operating
temperature (STANDBY mode). The machine
will beep 3 times if one of these functions
is selected.
SELECT
TEMP TEXTURE
HOT WATER AMERICANO
13