Breville Oracle Instruction Book page 24

Steam Temperature (StEA)
Adjust the steam boiler temperature,
which in turn controls steam pressure. Rotate
SELECT dial to the desired temperature. The
default is 266˚F (130˚C). Press SELECT
dial to set. Machine will beep once to
confirm selection.
Air Pump Delay (Air)
This function is for advanced use only. Delay
the operation of the air pump during automatic
milk texturing. Rotate SELECT dial to the
desired delay time. The default setting is 02
seconds. Press SELECT dial to set. The default
temperature which the air pump turns off
will be displayed. Rotate SELECT dial to the
desired temperature. Press SELECT dial to set.
Machine will beep once to confirm selection.
Sound (Snd)
Adjust the audible alerts. Rotate SELECT dial
to the desired setting. Select between off (OFF),
low (Lo) or high (Hi). Press SELECT dial to
set. Depending on the selected setting, the
machine may beep once to confirm selection.
Fan Control (FAn)
Adjust the speed of the internal cooling fan.
Rotate SELECT dial to the desired fan speed.
Select between Silent (SILt), Standard (StNd)
or cool (CooL). Press SELECT dial to set.
Machine will beep once to confirm selection.
Disable Clean Me! Alert (Cln)
Disables the 'CLEAN ME!' alert. Rotate
SELECT dial to on (On) or off (OFF). The
default setting is on. Press SELECT dial to set.
Machine will beep once to confirm selection.
12H or 24H Clock (CLoC)
Display time in 12h or 24h format. Rotate
SELECT dial to the desired unit. Press SELECT
dial to set. Machine will beep
once to confirm selection.
24
Flow Measurement Method (VoL)
Select between volume based (FLo) or
time based (SEc) method for espresso dose
measurement. Rotate SELECT dial to the
desired method. Press SELECT dial to set.
Machine will beep once to confirm selection.
ALERTS
MANUAL will flash on steam LCD
The machine will not reach operating
temperature (STANDBY mode) if the steam
lever is in the MANUAL position. The steam
LCD will display 'MANUAL'. Lower the steam
lever to the center OFF position.
Steam operation is ready when the SELECT
dial illuminates.
Fill Tank
The machine will detect a low water level. The
LCD will display 'FILL TANK'.
Fill tank with cold fresh water. The machine
will not be able to make coffee or hot water
while the tank is empty.
Clean Me!
Indicates when 200 extractions have been
carried out since the last cleaning cycle.
The cleaning cycle cleans the shower
screen and back-flushes the group head. For
information on how to clean the machine, refer
to `Cleaning Cycle', page 30.