Nortel 2245 Installation And Configuration Manual page 98

Page 98 of 206 WLAN Handsets 2210/2211 configuration
553-3001-304 Standard 3.00
• The supported IP Telephony system is connected to the network and
completely operational.
• A TFTP Server is available on the network to load the appropriate
software into the wireless handsets.
• The Battery Pack on the wireless handset is fully charged.
Follow the steps in Procedure 10 on
software.
Procedure 10
Downloading the wireless handset software
1 Download the latest WLAN Handset 2210 and WLAN Handset 2211
software from the Nortel Networks web site.
2 Load the latest version of the WLAN Handset 2210 and WLAN Handset
2211 UNIStim code software and place it on the TFTP Server. Ensure the
TFTP Server is started.
The three files that are needed are named:
— slnk_cfg.cfg
— pd11usc.bin
— phintl24.bin
3 If statically assigning IP addresses, ensure that the wireless handset IP
address, TFTP Server IP address, Subnet Mask, and Default Gateway
information are accurate in the wireless handset's Admin Menu. If using a
DHCP Server, ensure that the DHCP options are configured.
4 Ensure the wireless handset has properly configured ESSID and Reg
Domain Information within the Admin Menu. If broadcast ESSIDs are
accepted at the APs, the handset automatically learns the ESSID
information when powering on.
5 Using the Admin Menu on the wireless handset, ensure the License
Management menu option is set to 010. This ensures the handset will
check for the proper UNIStim software files each time it powers on.
6 Power on the wireless handset.
The software now downloads to the wireless handset. The status bar
increments fully across the wireless handset display for each function that
is being performed in the download process.
September 2004
page 98 to download the wireless handset