Nortel 2245 Installation And Configuration Manual page 169

Appendix A: WLAN Application Gateway 2246
2 Enter the configuration information for the WLAN Application Gateway
2246, as provided by the network administrator.
• Ethernet Address – this is the MAC address of the WLAN
Application Gateway 2246. This address is set at the factory.
• IP Address – enter the complete IP address for the WLAN
Application Gateway 2246, including digits and periods. Do not use
DHCP. The IP address can be changed after initial configuration.
• Hostname – the default host name can be changed. This is the name
of the WLAN Application Gateway 2246 to which connection has
been made. This name is for identification purposes only. Spaces
cannot be entered in this field.
• Subnet Mask – Enter the subnet mask defined by the network
administrator.
• Default Router – DHCP or static IP address.
• Allow Telnet Connections – Enter Y (Yes) to allow connection to
the WLAN Application Gateway 2246 through Telnet. Enter N (No) if
no Telnet connection is allowed.
• Allow FTP Connections – Yes/No (MOG 7xx only).
• DNS server and DNS domain – these settings are used to configure
Domain Name Services (DNS). (These settings can also be
configured as DHCP. This causes the DHCP client in the WLAN
Application Gateway 2246 to attempt to automatically obtain the
correct configuration from the DHCP server. The DHCP setting is
only valid when the IP address is also acquired using DHCP).
• WINS servers – these settings are used for Windows Internet Name
Services (WINS). (These settings can also be configured as DHCP.
This causes the DHCP client in the WLAN Application Gateway 2246
to attempt to automatically obtain the correct setting from the DHCP
server. The DHCP setting is only valid when the IP address is also
acquired using DHCP. When WINS is configured properly, the WLAN
Application Gateway 2246 can translate hostnames to IP addresses.
When using Telnet, it is also possible to access the WLAN
Application Gateway 2246 using its hostname instead of the
IP address.
• Logging – Logging can be set to Syslog or NONE.
• Log server – enter the IP address or hostname of the Syslog server
on the network if Syslog has been configured. The WLAN Application
WLAN IP Telephony
Page 169 of 206
Installation and Configuration