Nortel 2245 Installation And Configuration Manual page 143

Table 19
Wireless handset status messages (Part 8 of 11)
Message
No Net Access
No Net Found
No Reg Domain
Not Installed!
Press End Call
Restart Command
Description
Cannot authenticate/associate
with AP.
This indicates any of the
following:
• No radio link. Verify that the
AP is turned on.
• No ESSID – Autolearn not
supported or incorrect ESSID
• Out of range
Incorrect WEP settings
•
Regulatory Domain not set.
A required software component
is missing.
The call has ended.
The wireless handset received a
restart command from the Call
Server.
WLAN IP Telephony
Troubleshooting
Action
Verify the AP configuration.
Verify that the AP is turned on.
Verify the ESSID of the wireless
LAN and enter or Autolearn it
again if required.
Try getting closer to an AP.
Check to see if other wireless
handsets are working within the
same range of an AP. If so,
check the ESSID of this wireless
handset.
Verify that all the WEP settings
in the wireless handset match
those in the APs.
Configure the Regulatory
Domain of the wireless handset.
Check that all required software
files are on the TFTP Server, if
over-the-air downloading is
being used. If the error repeats,
contact Nortel Networks
Technical Support.
Press the Power Off / End Call
key to return to standby mode.
None. The wireless handset will
automatically restart in a few
seconds.
Installation and Configuration
Page 143 of 206