Nortel 2245 Installation And Configuration Manual page 141

Table 19
Wireless handset status messages (Part 6 of 11)
Message
Initializing ...
Internal Err. # #
Multiple GW
Network Busy
No Func. Code
No Host IP
No IP Address
Description
The wireless handset is
performing a power-on
initialization.
The wireless handset has
detected a fault from which it
cannot recover.
The wireless handset is
attempting to communicate with
two WLAN IP Telephony
Managers 2245.
All APs are full or busy.
Download error. Wireless
handset unable to find software
to download.
The wireless handset is
configured for "static IP" (as
opposed to "use DHCP") and no
valid host IP address (the
wireless handset's IP address)
has been entered.
Invalid IP address.
WLAN IP Telephony
Troubleshooting
Action
None. This is informational only.
Record the error code so it can
be reported. Turn the wireless
handset off, then on again. If
error persists, try registering a
different wireless handset to this
telephone port. If error still
persists, contact Nortel
Networks Technical Support and
report the error.
Check the WLAN IP Telephony
Managers 2245 configuration.
More than one master may be
configured.
Try call again later.
Correct the configuration to
enable the wireless handset to
find the software on the TFTP
Server.
Enter a valid IP address in the
configuration settings or change
to "use DHCP".
Check the IP address of the
wireless handset and
reconfigure if required.
Installation and Configuration
Page 141 of 206