Table of Contents
Advertisement
1.6
Connecting and powering on the cutter
1.6.1
Turning on the cutter
Warning:
Before connecting the machines to the power supply, make sure that each
cover on each module has been reinstalled and that any part of the machine
that was disassembled during installation was put back in place. Do not
connect the machines to the power supply if covers are off or if any module
is (even partially) disassembled. Make sure you use a proper grounded
plug in the wall outlet. Never plug in the module to a non-grounded plug.
Warning:
Before turning on the machines, make sure that each cover on each module
has been replaced and that any part of the machine that was disassembled
during installation was put back in place. Do not turn the machines on if
covers are off or if any module is (even partially) disassembled.
1. Securely plug the power cord [A] into the mains socket [B] on the rear
panel and connect to an electrical outlet of the specified voltage.
2. Turn on the power using the mains switch [C].
3. After the Warning screen appears on the LCD panel, press the Enter
key. This action will prompt the cutter head to automatically return to its
Home position. Once it reaches the Home position, the cutter will be in
an Online state, fully prepared and ready for use.
SC6500
1.6.2
Connecting to computer
The ColorCut Pro software includes the USB and Ethernet drivers built into
the software. There is no need to install any addition drivers.
Note: Operation can not be guaranteed in the following circumstances:
1) When connection is made through a USB hub or an add-on USB board.
2) When you are using a custom-built computer that has been modified.
For optimal results, please ensure the following:
• Do not connect or disconnect the USB/Ethernet cable while you are
installing the Color Cut Pro software.
• Do not connect or disconnect the USB/Ethernet cable while starting up
the computer.
• Do not connect or disconnect the USB/Ethernet cable while switching
on the cutter.
• Do not disconnect the USB/Ethernet cable within a 5 second period of
connecting it. (It does not always recognise the fact it was subsequently
disconnected and won't reconnect again until you power-cycle both
devices)
• Do not disconnect or connect the USB/Ethernet cable while you are
cutting a job, or while data is being transferred.
C
B
A
1. Plug the USB cable [A] into the USB socket [B] on the rear panel and
connect to your Windows PC; or plug the Ethernet cable into the socket
on the rear panel and connect to your Ethernet socket.
3 January 2024
1-21
B
A
Installation Procedure
Advertisement
Table of Contents
