c. Power cycle the storage enclosure by removing both right-angle power cord connectors from both PCMs.
d. Examine the controller module system log for errors.
Interpret FRU fault condition LEDs
Throughout the storage enclosure, amber LEDs indicate a fault condition. Some FRUs are more complex than others, so
have more than one fault condition. Those items in the state column with an asterisk (*) indicate a fault condition.
Disk drive fault LED
The disk drive uses an amber fault LED to identify various states. Those items in the state column with an asterisk (*)
indicate a fault condition.
Color
State
Off
None
On*
Amber
Flashing*
Figure 46 Disk drive fault LED on top panel
SAS expander module fault LED
The SAS expander module component side has a green activity LED, labeled LED 3 on the PCBA, and an amber fault
condition LED, labeled LED 2 on the PCBA. Both LEDs can be difficult to view from the top, since the component side
faces the chassis sidewall. Those items in the state column with an asterisk (*) indicate a fault condition.
Item
LED number: Name
1
3: Activity
2
2: Fault condition
Figure 47 SAS expander module LEDs, component side
Status
No AC power is present or the disk drive is functioning normally.
The disk drive has a hardware fault. Replace as soon as possible.
Fast flash (1 s) : The disk drive is identifying itself to the system software. Not a fault.
l
Slow flash (3 s) *: See the system log for identified fault conditions.
l
1
2
Color
State
Status
Off
No AC power is present.
Green
Flashing
The firmware is active, the SAS expander module is functioning normally.
Off
The firmware has not set a hardware fault condition.
Amber
On*
The firmware has set a hardware fault condition.
Chapter 6 Hardware installation and configuration issues
53