Figure 11 Distance Measurement Of Rack Inside Post-To-Post Depth; Figure 12 Default Location Of Outer Rail Adjustment Setscrews - Seagate Exos CORVAULT Hardware Installation And Maintenance Manual

To adjust the outer rails to the rack cabinet:
1. Facing the left side of the rack cabinet, measure the distance of the post-to-post depth between the inner side of the
rear and front rack posts.

Figure 11 Distance measurement of rack inside post-to-post depth

2. Select the left outer rail assembly, rotating it so you face the mid rail and the outer rail is facing away from you.
3. Rotate the mid rail release switch lever, then extend the mid rail until it locks.
4. If the distance you measured is not between the default 34 and 35 inches, use a #2 Phillips-head screwdriver to
remove and set aside all four rear mount bracket setscrews.

Figure 12 Default location of outer rail adjustment setscrews

Chapter 3 Initial installation
23