Adjust The Outer Rails To The Rack Cabinet; Figure 10 Location Of Mid Rail Release Switch Lever - Seagate Exos CORVAULT Hardware Installation And Maintenance Manual

Figure 10 Location of mid rail release switch lever

8. Rotate the mid rail release switch lever to release it, then slide the left mid rail back until fully retracted onto the
outer rail.
9. Set aside the left outer and mid rail subassembly near the left inner rail.
10. Separate the right rail using the same process, keeping the separated right rails in an alternate location as the mirror
image of the separated left rails.
11. Inspect the rails once again for any damage or warping. If you locate either, return them in their shipping carton.

Adjust the outer rails to the rack cabinet

You must correctly attach the outer rails to the rack cabinet. After successful installation, the storage enclosure must slide
smoothly on the rails from fully inserted, out to the service position, and back again.
Required equipment
Outer rails, properly oriented
A retractable tape measure
#2 Phillips-head screwdriver, 6-in length
Panhead screw, M4x4mm length
CMA B bracket
22 Chapter 3 Initial installation
Qty Identification
2
1
1
4
1
N/A
N/A
N/A