Install The Cma And Crossbar - Seagate Exos CORVAULT Hardware Installation And Maintenance Manual

Install the CMA and crossbar

The cable management arm (CMA) is essential to the storage enclosure and allows for full extension to the service
position. It also ensures efficient and effective storage enclosure connectivity. The crossbar stabilizes the rear rails,
keeps them parallel to each other, and protects them from inadvertent sideways forces that could damage their
function.
Required equipment
CMA bracket assembly
Crossbar
#2 Phillips-head screwdriver, 6-in length
(Optional) Panhead screw, M5 0.8x4mm length
(Optional) Truss head screws, 10-32x3/4 in length
(Optional) Cage nut, 10-32 for rack posts with square mounting
holes
To install the CMA and crossbar:
1. Facing the rear of the rack cabinet, grasp the CMA bracket assembly so that arrows by embossed letters point
upward and are visible to you, then fully extend the CMA bracket with the front end in your right hand.
2. Route the front end of the CMA bracket assembly in your right hand along the chassis guide bracket until it clips to
the CMA A bracket you previously attached to the storage enclosure chassis.
34 Chapter 3 Initial installation
Qty Identification
1
1
1
2
2
2:4
N/A