DICENTIS
4.2
Wireless Device initialization
Figure 4.1: DCNM‑WD(E) Wireless Device bottom view
Preconditions Wireless Devices and DCNM-WAP
–
–
A Wireless Device is de‑initialized when all LEDs on the Wireless Devices are on. To de-
initialize a Wireless Device, use a thin screwdriver to press and hold in the De‑init button on
the base of the Wireless Device (1) until all LEDs are on.
Preconditions web interface application
–
Initialization
1.
2.
3.
4.
5.
Bosch Security Systems B.V.
1
The DCNM-WAP must be powered on and configured. Refer to First use configuration,
page 7, if required.
All Wireless Devices must be:
–
placed within the range of the DCNM-WAP.
–
powered on (by inserting the Battery Pack and pressing the microphone request
button).
–
de‑initialized.
The logged in user must have the access right: Configure system.
Log in to the web interface application, and go to the Seats page. Refer to Seats, page
20.
Enable the Subscription mode.
Press the microphone request button of a Wireless Device.
–
The Wireless Device starts subscribing, and the LED-bar above the microphone
request button starts alternating between red and green.
–
When the LED-bar is off, the Wireless Device is subscribed.
Wait until a Wireless Device is subscribed before subscribing the next Wireless Device.
Subscribing a Wireless Device before the previous device has finished subscribing will
result in overlap.
–
In overlap, the subscription is disabled for 2 minutes, which is shown in the web
interface application.
–
Starting subscription before the current overlap time period has finished will restart
the overlap time period of two minutes.
–
If another WiFi system is in subscription mode, this will also activate the overlap
period in the DCNM-WAP.
When all Wireless Devices are subscribed, disable the Subscription mode in the web
interface application. The subscription mode will automatically switch off after 2 minutes.
Configuration manual
First use configuration | en
2015.03 | V1.0 |
9