Draining Waste Water / Recycling Water; Cleaning The Waste Container; Cleaning The Vehicle; High-Pressure Cleaner Attachment (Ex-Factory) - Kärcher MC 250 Implements Manual

1.6.3 Draining waste water / recycling water

Drain the waste water or recycling water only in a suitable
area.
Figure: Draining waste water / recycling water
1. Park the vehicle in a suitable area for draining.
2. Switch on the vehicle and press the Drain recycling wa-
ter switch.
3. Drain the waste water or recycling water.

1.6.4 Cleaning the waste container

Clean the suction mouth and the suction system first be-
fore cleaning the waste container. See chapter "Cleaning
the suction mouth and suction system".
Interior of waste container
1
Side channels
2
Rod engaged
3
Blower flap
4
Retaining clip
5
Exhaust grille
6
1. Park the vehicle.
2. Raise the waste container into the emptying position.
3. Rinse the inside of the sweep container and the side
channels with water.
4. If necessary, rinse the exhaust grille with water by pull-
ing out the retaining clips on the left and right and pivot-
ing the blow-out grille down.
5. Rinse the outside of the blower flap with water, first open
the blower flap with the rod (the rod engages).

1.6.5 Cleaning the vehicle

The vehicle with the waste container can be cleaned with
a high-pressure cleaner.
34
 Clean critical areas such as bearings, tyres, etc. with re-
duced pressure and without a rotary nozzle.
 Do not clean areas with electrical components with the
high-pressure cleaner.
Figure: Cleaning the vehicle
1.7 High-pressure cleaner attachment (ex-
factory)
The high-pressure cleaner attachment kit is included in the
scope of delivery and already installed in the vehicle when
ordered ex-factory.
This chapter describes operation and care.
High-pressure cleaner
1
High-pressure hose reel
2
Nozzle holder
3
Fastening trigger gun
4
Waste container flap
5
Oil level sight glass
1
Oil drain plug
2
Water filter
3
Water connection
4
English