Table of Contents
Advertisement
2
■
Connect the hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
■
Operate ATC as stand alone using computer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
■
Program and execute a run on the ATC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
■
Connect to multiple instruments using the desktop software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
■
Firmware upgrades . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
This chapter describes the procedures for setting up and running the Automated Thermal Cycler (ATC)
System as a stand-alone system.
Connect the hardware
1. Connect the connector cable into the insertion points on the ATC block (Figure 1, item 4) and base
module (Figure 2, item 1)
Note: Ensure the DSUB connector is securely fastened.
2. Connect the power cable into the back of the ATC control module (Figure 1, item 1)
3. Connect the ethernet cable into the control module (Figure 1, item 3) and into the
computer/network that you will be using to control the ATC.
4. Power on the ATC.
Operate ATC as stand alone using computer
Make sure all hardware connections are completed.
1. Download the ATC desktop software at
found in the software release notes.
Note: To fully install the software, the computer will need to be connected to the internet. Once
the software is fully installed, disconnect the computer from the internet for best performance with
the ATC desktop software.
Automated Thermal Cycler (ATC) System User Guide
Operate the Automated Thermal
Cycler (ATC) System as a stand-
thermofisher.com
alone system
and follow the installation instructions
15
Advertisement
Table of Contents
