Table of Contents
Advertisement
Electrical safety
WARNING! Ensure appropriate electrical supply. For safe operation of the instrument:
·
Plug the system into a properly grounded receptacle with adequate current capacity.
·
Ensure the electrical supply is of suitable voltage.
·
Never operate the instrument with the ground disconnected. Grounding continuity is required for
safe operation of the instrument.
WARNING! Power Supply Line Cords. Use properly configured and approved line cords for the
power supply in your facility.
WARNING! Disconnecting Power. To fully disconnect power either detach or unplug the power
cord, positioning the instrument such that the power cord is accessible.
Cleaning and decontamination
CAUTION! Cleaning and Decontamination. Use only the cleaning and decontamination methods
specified in the manufacturer's user documentation. It is the responsibility of the operator (or other
responsible person) to ensure the following requirements are met:
·
No decontamination or cleaning agents are used that could cause a HAZARD as a result of a
reaction with parts of the equipment or with material contained in the equipment.
·
The instrument is properly decontaminated a) if hazardous material is spilled onto or into the
equipment, and/or b) prior to having the instrument serviced at your facility or sending the
instrument for repair, maintenance, trade-in, disposal, or termination of a loan (decontamination
forms may be requested from customer service).
·
Before using any cleaning or decontamination methods (except those recommended by the
manufacturer), users should confirm with the manufacturer that the proposed method will not
damage the equipment.
Instrument component and accessory disposal
To minimize negative environmental impact from disposal of electronic waste, do not dispose of
electronic waste in unsorted municipal waste. Follow local municipal waste ordinances for proper
disposal provision and contact customer service for information about responsible disposal options.
Safety and electromagnetic compatibility (EMC) standards
The instrument design and manufacture complies with the following standards and requirements for
safety and electromagnetic compatibility.
Automated Thermal Cycler (ATC) System User Guide
Safety and electromagnetic compatibility (EMC) standards
Appendix D Safety
D
63
Advertisement
Table of Contents
