Pylontech PowerCube-H1 Product Manual page 20

B. System turn On
Double check all the power cables and communication cables. Make sure the voltage of the
inverter is same level with the battery system.
(1) Switch battery system power on.
All the control modules and the battery modules' green LED light (status and capacity) as below
will be on:
If all the LED light on as normal, which means the battery system is good and working.
(2) In the monitor check the battery system's working status.
(3) Turns the high voltage DC power switch on.
C. System turn off
(1) Turn off the System Switch.
(2) The Power Output Switch normally needn't switch off.
Caution:
Before change the battery module for service, must charge/discharge the replaced battery
same voltage to the other in system battery modules. Otherwise the system need long time to do
the balance for this replaced battery module.
NOTE
After installation, do not forget to register online for full warranty:
www.pylontech.com.cn/service/registration
20 / 23
17PIHV1101