Weld Editor In Job Mode - ABB Fronius TPS 320i Applications Manual

4.3 Weld editor in Job mode

Ignition parameters
Tap the Ignition tab to view or modify the ignition phase parameters.
xx1900002410
Button
Refresh
Confirm
Cancel
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
3HAC065012-001 Revision: C
Note
Do not manipulate seam/welddata using the RAPID data type editor. This can
result in unwanted behavior and wrong welding parameters which can in worst
case damage your welding equipment. Use the Weld mode editor instead.
Note
The ignition phase parameters can only be modified in manual mode.
Tip
To copy the current weld phase mode settings, toggle Use Weld Phase Mode
off, on, and then off again.
Description
The blue refresh button is used to return to the Weld Phase tab.
The green check button is used to confirm any changes made.
The red cancel button is used to cancel any changes made and return
to the previous values.
© Copyright 2004-2021 ABB. All rights reserved.
4 Weld editor interface
4.3 Weld editor in Job mode
Continues on next page
45