ABB Fronius TPS 320i Applications Manual page 39

Parameter
Purge Time
Pre Flow Time
Scrape Start
Use Weld Phase Mode
Synergic Line
Wire Feed Speed
Arc Length Correction
Pulse/Dynamic Corr.
Heat parameters
Tap the Heat tab to view or modify heat phase parameters.
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
3HAC065012-001 Revision: C
Note
The heat phase parameters can only be modified in manual mode.
Tip
To copy the current weld phase mode settings, toggle Use Weld Phase Mode
off, on, and then off again.
© Copyright 2004-2021 ABB. All rights reserved.
4.2 Weld editor in Program mode
Description
The time (in seconds) it takes to fill the gas lines and the welding
gun with protective gas, also called gas purging.
The time (in seconds) it takes to pre-flow the weld object with
protective gas, also called gas pre-flow.
The type of scrape used at the weld start. Scrape type at restart
will not be affected. It will always be weaving scrape.
• Not selected – No scrape at weld start
• Selected – weaving scrape
Not selected – Select weld parameters during ignition phase
manually.
Selected – Use the parameters from the Weld tab. This is the
default mode.
Mode defines the shape and characteristics of the weld. The
characteristics of a mode generally implement the process:
Standard, Pulse, LSC, PMC and CMT.
The information displayed in the Synergic Line is:
SynergicLine number, Wiresize, GasType, Material, Pro-
cessType.
This is the wire feed speed. The values apply to the MIG/MAG
standard synergic, MIG/ MAG pulse synergic, MIG/MAG PMC
and MIG/MAG LSC welding processes.
This parameter represents the arc length when welding in syn-
ergic mode the range is -10 to +10. The values apply to the
MIG/MAG standard synergic, MIG/MAG pulse synergic,
MIG/MAG PMC and MIG/MAG LSC welding processes.
(-10% = shorter arc, 0% = value from line, +10% longer arc)
The actual value range in Volts is also shown as, Actual <x.x –
y.y> [V]
Arc-force dynamic correction or pulse correction (pulsed arc).
The range is -10 to +10.The values apply to the MIG/MAG
standard synergic, MIG/MAG pulse synergic, MIG/MAG PMC
and MIG/MAG LSC welding processes.
(-10% = pulse-/dynamic correction, 0% = value from line, +10%
= pulse-/dynamic correction)
4 Weld editor interface
Continued
Continues on next page
39