ABB Fronius TPS 320i Applications Manual page 46

4 Weld editor interface
4.3 Weld editor in Job mode
Continued
Parameter
Ign Move Delay
Purge Time
Pre Flow Time
Scrape Start
Use Weld Phase Mode
Job number
ProcessType
Heat parameters
Tap the Heat tab to view or modify heat phase parameters.
Continues on next page
46
Note
The heat phase parameters can only be modified in manual mode.
Tip
To copy the current weld phase mode settings, toggle Use Weld Phase Mode
off, on, and then off again.
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
© Copyright 2004-2021 ABB. All rights reserved.
Description
The delay (in seconds) from the time the arc is considered stable
at ignition until the heat phase is started.
The time (in seconds) it takes to fill the gas lines and the welding
gun with protective gas, also called gas purging.
The time (in seconds) it takes to pre-flow the weld object with
protective gas, also called gas pre-flow.
The type of scrape used at the weld start. Scrape type at restart
will not be affected. It will always be Weaving scrape.
• Not selected – No scrape at weld start
• Selected – Weaving scrape
Not selected – Select weld parameters during ignition phase
manually
Selected – Use the parameters from the Weld tab. This is the
default mode.
The job (schedule) that should be selected within the welder.
The information displayed in the Job number is:
Job number, Job name.
The process type that is active for the selected job.
Available process types are:
• MIG/MAG Pulse Synergic
• MIG/MAG Standard Synergic
• MIG/MAG PMC
• MIG/MAG LSC
• MIG/MAG Standard Manual
• Electrode
• TIG
3HAC065012-001 Revision: C