ABB Fronius TPS 320i Applications Manual page 66

5 The Fronius TPS/i RobotStudio Add-In
5.2 Overview of the Fronius TPS/i Add-In
Continued
The selection on the left side represents all available weld modes in the welder.
You can simply apply the filters and then copy the selection (you can apply
multiselect) to the left right side. This represents the modes currently available in
the welder. If there are already some modes installed, they will be presented, and
you can update the list.
The checkbox Show line will present a graph of the selected weld mode on
controller side.
xx1900002432
Once the weld modes are selected, click on OK.
Button
Search
Select All
Clear all
Delete
OK
Cancel
Continues on next page
66
Note
The selection needs to be downloaded to the controller before they are active.
This is done by clicking Update Controller.
Description
This will start the search the weld modes based on the filters.
This will select all weld modes that have been found.
This will delete all weld modes in the selection, but the controller will not be
updated if Auto Update Controller is not checked. (Update must be done by
clicking Update Controller).
This will delete the selected weld modes on controller side, but the controller
will not be updated if Auto Update Controller is not checked. (Update must
be done by clicking Update Controller).
Apply the settings.
Cancel the settings.
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
© Copyright 2004-2021 ABB. All rights reserved.
3HAC065012-001 Revision: C