ABB Fronius TPS 320i Applications Manual page 41

Parameter
Arc Length Correction
Pulse/Dynamic Corr.
Weld parameters
Tap the Weld tab to view or modify weld phase parameters.
xx1900002407
Button
Refresh
Confirm
Cancel
Parameter
Weld speed
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
3HAC065012-001 Revision: C
Note
The weld phase parameters can only be modified in manual mode.
Description
The blue refresh button is used to return to the Weld Phase tab.
The green check button is used to confirm any changes made.
The red cancel button is used to cancel any changes made and return
to the previous values.
© Copyright 2004-2021 ABB. All rights reserved.
4.2 Weld editor in Program mode
Description
This parameter represents the arc length when welding in syn-
ergic mode the range is -10 to +10. The values apply to the
MIG/MAG standard synergic, MIG/MAG pulse synergic,
MIG/MAG PMC and MIG/MAG LSC welding processes.
(-10% = shorter arc, 0% = value from line, +10% longer arc)
The actual value range in Volts is also shown as, Actual <x.x –
y.y> [V]
Arc-force dynamic correction or pulse correction (pulsed arc).
The range is -10 to +10.The values apply to the MIG/MAG
standard synergic, MIG/MAG pulse synergic, MIG/MAG PMC
and MIG/MAG LSC welding processes
(-10% = pulse-/dynamic correction, 0% = value from line, +10%
= pulse-/dynamic correction)
Description
The speed of the TCP of the welding torch during the weld in-
struction.
4 Weld editor interface
Continued
Continues on next page
41