ABB Fronius TPS 320i Applications Manual page 50

4 Weld editor interface
4.3 Weld editor in Job mode
Continued
Parameter
Use Weld Phase
Job number
ProcessType
50
Description
Not selected – Select weld parameters during ignition phase
manually.
Selected – Use the parameters from the Weld tab. This is the
default mode.
The job (schedule) that should be selected within the welder.
The information displayed in the Job number is:
Job number, Job name.
The process type that is active for the selected job.
Available process types are:
•
•
•
•
•
•
•
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
© Copyright 2004-2021 ABB. All rights reserved.
MIG/MAG Pulse Synergic
MIG/MAG Standard Synergic
MIG/MAG PMC
MIG/MAG LSC
MIG/MAG Standard Manual
Electrode
TIG
3HAC065012-001 Revision: C