ABB Fronius TPS 320i Applications Manual page 54

4 Weld editor interface
4.4 Weld editor in Job mode with correction
Continued
Weld parameters
Tap the Weld tab to view or modify heat phase parameters.
xx1900002415
Button
Refresh
Confirm
Cancel
Parameter
Weld speed
Job number
Wire Feed Speed
Arc Length Correction
Continues on next page
54
Note
The weld phase parameters can only be modified in manual mode.
Description
The blue refresh button is used to return to the Weld Phase tab.
The green check button is used to confirm any changes made.
The red cancel button is used to cancel any changes made and return
to the previous values.
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
© Copyright 2004-2021 ABB. All rights reserved.
Description
The speed of the TCP of the welding torch during the weld in-
struction.
The job (schedule) that should be selected within the welder.
The information displayed in the Job number is:
Job number, Job name.
This is the wire feed speed (Power). In this mode, the wire feed
speed can be adjusted in the range of +/- 20 % in 1% incre-
ments.
This parameter represents the arc length (Voltage).
In this mode, the Arc Length Correction can be adjusted in the
range of +/- 10 steps in 0.1 increments.
3HAC065012-001 Revision: C