Daewoo D1146 Maintenance Manual page 79

specified torque.
Torque
3.3.9. Magnetic pick-up sensor
Move the lock nut to hexagonal side of
sensor completely.
Rotate (Clockwise) the pick-up sensor on
fly wheel housing, until the end of it reach
on fly wheel ring gear.
Then rotate (Counter clockwise) the
pick-up sensor for 270° (gap 1.0 mm)
and fix lock nut.
Tolerance limit is 27°. (gap ± 0.1 mm)
3.3.10. Water chamber cover
Coat the adhesive over the water
chamber cover (Particular around bolt
holes) and after attaching the gasket,
assemble it to the cylinder block using
the bolts for assembling.
As for tightening of bolts, after primarily
tightening the bolts located at the both
ends of cover (4ea at both sides) and
middle bolts (Upper, lower 2ea) , tighten
the rest.
3.3.11. Cylinder liner
Stand the cylinder block so that the
flywheel faces downward.
Thoroughly clean the liner flange
fitting
surface
18 kg.m
and bore inside
Lock nut
Flywheel
housing
with
75
D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
Tolerance
limit
Printed in Jan. 2001 PS-MMA0415-E1A