Daewoo D1146 Maintenance Manual page 61

4) Reassembling rocker arm assembly
Reassembling can be done in the reverse order of disassembling and following
things should be heeded
Check the oil supply hole of rocker arm shaft for any clog and clean
thoroughly.
Be careful not to occur any swap of position and reverse assembly.
3.2.4. Camshaft
(1) Camshaft end play
Push the thrust plate toward the cam
gear.
clearance between the thrust plate
and camshaft journal.
If the end play is excessive, replace
the thrust plate.
Standard
0.28 ∼ 0.43 mm
(2) Cam
Cam lobe height
Cam lobe height
(C)
Cam journal diameter (A,B) φ57.86 ∼ φ57.88 mm
Use a micrometer to measure the
cam
diameter.
If the measured number is less than
the specified limit, the camshaft
must replaced.
Cam surface
With a feeler gauge, measure
the
Limit
0.6 mm
Standard
Intake 49.15 mm
D1146/TI : 49.32mm
Exhaust
DE08TIS : 49.35mm
lobe height and
Limit
48.85 mm
49.00 mm
φ57.52 mm
journal
57
D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
Feeler gauge
M1095
Printed in Jan. 2001 PS-MMA0415-E1A