Daewoo D1146 Maintenance Manual page 68

5) Crank shaft end play
Assemble the crankshaft to the
cylinder block.
With a dial gauge, measure
crankshaft end play.
Standard
0.15 ∼ 0.325 mm
3.2.6. Piston assembly
(1) Disassemby of piston assembly
Disassemble
disassembly process.
(2) Piston inspection
1) Visual check
Visually check the pistons for cracks,
scuff or wear, paying particular attention
to the ring groove.
2) Clearance between the piston and cylinder liner
With an outside micrometer,
measure the piston outside diameter
at a point 13mm away from the lower
end of piston skirt in a direction at a
right angle to the piston pin hole.
Standard
Using a cylinder bore gauge,
measure
diameter at 3 points (cylinder top
ring contacting face, middle, and oil
ring contacting face on BDC) in a
direction at an angle of 45°. Take the
mean value with the largest and
smallest values excepted.
Limit
0.5 mm
piston according
φ110.883 ∼ φ110.897 mm
cylinder liner
64
to the
Position of measuring
outside diameter
G1095
inside
D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
Printed in Jan. 2001 PS-MMA0415-E1A