Daewoo D1146 Maintenance Manual page 76

Install the bearing and thrust
washers to
the bearing cap and apply oil to the bearing
and thrust washers.
Install the bearing cap by matching the
cylinder block No. with the bearing cap
No.
Apply oil to the entire part of the bearing
cap bolts, then tighten in tightening
sequence to specified torque.
Torque
After semi-tightening both bolts
evenly,
tighten them diagonally to the specified torque
using a torque wrench as follows.
<Tightening Order>
(1) First stage
(2) Second stage : Temporary bolt screwing about 1 ～2 threads
(3) Third stage
(4) Fourth stage : With torque wrench, tighten up to about 25 kg.m
(5) Fifth stage
30 kg.m
: Coat the cap bolts with engine oil
: With impact wrench, tighten up to about 15 kg.m
: By means of torque wrench, tighten finally in the specified
72
D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
Printed in Jan. 2001 PS-MMA0415-E1A