Daewoo D1146 Maintenance Manual page 78

shaft, then assemble the oil seal using an oil seal fitting jig.
3.3.8. Flywheel
Installation of flywheel ring gear
With a gas burner, heat the ring gear
evenly until heat expansion takes place,
then install it using a hammer.
CAUTION :
Do not allow the temperature of the ring
gear to exceed 200 °C (390 °F).
By means of mandrel, assemble pilot
bearing to the flywheel.
By means of mandrel, press in the wear
ring at the backward face.
Install a guide bar into a bolt hole on
the crank shaft, and lift the flywheel to
align the dowel pin with the pin hole on
the flywheel for temporary assembly
operation.
Coat the adhesive (#271 Loctite) over the
assembling bolts and install bolts in the
remaining holes. After that take out the
guide bar, then install a bolt in the hole
where the guide bar had been inserted.
According to the order of tightening
tighten the fixing bolts using a torque
wrench in a diagonal sequence to
wear ring
74
Printed in Jan. 2001 PS-MMA0415-E1A
D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
M1122
ring gear
G1031