Daewoo D1146 Maintenance Manual page 75

3.3.5. Crankshaft
Install the main bearing (refer to
assemble sequence : right figure)
machined with two holes in the cylinder
block so that the key is aligned with the
key groove, then apply oil to the bearing
surface.
Heat the crankshaft gear for at least 10
minutes to 120°C, then apply sealant
(Loctite # 641) to the inside wall of the
heated crankshaft gear evenly before
inserting it to the end of crankshaft.
Semi-tighten a bolt at both sides of the
crankshaft, apply engine oil to journals
and pins, then assemble the crankshaft
with the cylinder block by tightening the
fixing bolts.
CAUTION :
Coat engine oil to the pin and journal of
crankshaft.
Install the oiled thrust washers
with the
oil groove facing outward.
71
D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
G1051
Printed in Jan. 2001 PS-MMA0415-E1A