Table of Contents
Advertisement
Cleaning and Descaling
WARNING!
Risk of scalding by hot water under pressure.
Never attempt to remove the holder until the group is in cleaning mode.
When the cleaning process is complete, wait for approx. 3 seconds before
removing the handle.
ATTENTION!
When the cleaning program is finished, remove the handle and have the
water flow through the brewing group again to rinse all residues.
Repeat the cleaning process without the cleaning agent to remove all
residues of the cleaning powder, keeping the filter membrane in correct
place.
NOTE!
Once a day, rinse the brewing group and the holder without cleaning
agents (only with filter membrane and hot water).
Once a week, clean the brewing group and the holder with the cleaning
agent.
Gasket Cleaning
When the holder with coffee is inserted in the brewing group, residues are
accumulated on the surface of the lock. If the accumulation of residues is too
excessive, it may negatively influence the tightness between the holder and the
brewing group head. The residues may even lead to clogging of water supply line
through the brewing group head.
To prevent this, perform the following cleaning activities:
1. Insert the filter membrane into the holder filter (without a cleaning agent).
2. Fit the holder in the brewing group head, but when rotating it, do not press it in
entirely (the holder needs to be rotated in lightly).
3. Press the continuous operation
4. Perform opening and closing movements with the inserted holder, but do not
close the holder entirely.
Water overflows the surface of the holder lock and cleans it.
190160
button on the control panel.
EN
33 / 40
Advertisement
Table of Contents
