Replacement Of Lid Gasket; Replacement Of Upper Bar Silicone; Replacement Of Gas Spring - Orved IDEA 30 User And Maintenance Manual

17.6 REPLACEMENT OF LID GASKET

1) Raise the lid.
2) Remove the snap ring from fastening pin (fig. 3).
3) Pull the pin and tilt the lid back, resting it on a stable support
4) Remove the old gasket by sliding it out of its seat. Clean the seat of the gasket with neutral detergent
(fig. 5).
5) Starting at the centre back of the seat in the cover (on the side of the hinges), fit the gasket in all the
way round (fig. 6) paying attention to:
a) Make the two junctions precisely and clean.
b) Check the lip of the gasket faces outwards.
c) Do not stretch the gasket when fitting it in.
6) Re-position the gas spring, inserting the pin and locking it in place with the snap ring previously
removed (fig. 7).
7) Run a cycle with setting the maximum vacuum level. When the maximum pressure is reached, turn off the
machine at the main switch: the chamber will be pressurized with the cover down.
Wait for 5 minutes with the cover closed and the chamber pressurized, to check successful operation. The
lid must remain closed and adherent to the vacuum chamber.
_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for
(fig. 4).
IDEA vacuum packing machines Pag. 68 a 76

17.7 REPLACEMENT OF UPPER BAR SILICONE

1) Raise the lid.
2) Remove the silicone profile from the upper bar
(fig.1).
3) Clean the seat thoroughly with a cloth soaked in
alcohol.
4) Put in a new silicone profile, pushing it in a uniform
manner. Do not stretch the silicone profile when
fitting it in.

17.8 Replacement OF gas SPRING

1) Remove the rear cover by pushing it upwards.
2) Raise the lid.
3) Remove the snap ring from fastening pin.
Pull the pin and tilt the lid back, resting it on a stable support.
4) Remove the gas spring from below.
5) Unscrew the gas spring (A) from the sliding pin (B), by turning it counter clockwise. Screw the new gas
spring to the sliding pin.
6) Insert the new gas spring from below.
_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for IDEA vacuum packing machines Pag. 69 a 76